Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 15
2.1 CUTTER BLADES (An overview of Blade types)
Name
Image
Angle
Blade
Diameter
Features and Application
Blade
30
O
1mm
For Film, very soft material, thin
label material.
45
O
1mm
Typically for labels, stickers,
and thin paper/card,
60
O
1mm
For thick media. The sharply
angled tip provides a longer
cutting edge. Suitable for cutting
media from 0.5 to 1.5 mm thick.*
Circlip
Knife
45
O
1.4mm
Most packing board up to 500
micron. Circlip provides better
pressure and improves blade
direction changes on dense media.
Suitable for cutting media from 0.25
to 0.5 mm thick
60
O
1.4mm
For cutting high-intensity reflectiv
film, magnetic media or thick media
The sharply angled tip provides a
longer cutting edge. Suitable for
cutting media from 0.5 to 1.5 mm
thick.* For cutting sandblast rubber.
Creasing
Blade
Bearing-based creasing ball,
double-ended for different width
creasing. Suitable for media ≤500g
Cardboard, corrugated paper
Pen
Holder
Used at setup, to calibrate the offset
between the Optical Registration
Mark sensor (Red light) and the
centre of Tool1 (The blade).
* Maximum cutting depth is defined by the machine type rather than the blade (which is 600 mic ons)
Your cutter comes with a selection of blades. The blades are packed in a foam
packing material. In addition to this there is a colored rubber protective cap. The
yellow caps indicate 30
O
, red caps indicate a 45
O
blade while the blue caps are 60
O
blades. Be careful when handling the blade as the cutting end is very sharp. Blades
are selected for different applications; a guide is shown below:
Summary of Contents for ColorCut FB1150 Series
