Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 28
3.3.5 Output device
Check your cutter is connected to and recognised by your computer.
If the Intec ColorCut Pr o software cannot sense an Intec ColorCut Flatbed cutter on
the USB connection of your computer , then under the “Output Device” option in the
[SETTINGS] window it will show: “
File Output”
.
In such circumstances, check your connection to your computer and power cycle your
Intec ColurCut Flatbed cutter. (Ensure it is off for 45 seconds to enable the USB cache
to flush). Check that you have cleared the SAFETY MESSAGE that appears at power
on, on the LCD panel of the cutter AND that the FB550 cutter is
ON-LINE
.
If the connection to your cutter
is successful then under the
Output Device option
C
you
will see the term USB Printing
Support.
(After a short delay
, the
identifier ‘FB550’ may appear
after the description ‘USB
Printing Support’. However
you don’t need to wait for
this and this may take a few
minutes to appear).
NOTE: The FB550 must be READY and
ON-LINE for the ColorCut Pro
software to communicate to it and establish what type of cutter it is. The
device may be seen as USB Printing Support and will not show the device
name if the cutter is off-line check the cutter is On-Line before sending any
jobs.
2
Summary of Contents for ColorCut FB1150 Series
