rear castor
bolt
handle
saddle
front wheel
1
BEFORE USE
Inspect before each use. Do not use if broken, bent,
cracked or otherwise damaged parts are noted. If the
jack has been or suspected to have been subjected
to a shock load, discontinue use until checked out by
an authorized factory service center. Owners and
operators of this equipment shall be aware that the
use and subsequent repair of this equipment may
require special training and knowledge. It is
recommended that an annual inspection be done by
qualified personnel and that any missing or damaged
parts, decals, warning / safety labels or signs be
replaced with factory authorized replacement parts
only. Any jack that appears to be damaged in any
way, is worn or operates abnormally should be
removed from service immediately until such time as
repairs can be made.
OPERATION
To Lift: Assemble 2 pc. handle and secure with handle
sleeve bolt. Always use wheel chocks to secure the
vehicle in order to help prevent inadvertent movement.
Use handle (as shown in Fig 1) to position the jack
near an approved lifting point. Close the release valve
by turning handle clockwise until it is firmly closed.
Pump handle to raise load.
To Lower: Raise load high enough to carefully remove
jack stands. Turn handle carefully and slowly
counterclockwise. If load fails to lower, carefully
transfer the load to another lifting device and stands.
Carefully remove affected jack and stands. Lower the
load by slowly turning the release valve no more than
1/2 full turn.
Save these instructions.
For your safety, read and understand the information contained within. The owner
and operator shall have an understanding of the product and safe operating procedures before attempting to
use this product. Instructions and Safety information shall be conveyed in the operators native language before
use of this product is authorized. Make certain that the operator thoroughly understands the inherent dangers
associated with the use and misuse of the product.
If any doubt exists as to the safe and proper use of this product as outlined in this factory authorized manual,
remove from service until which time it is clear. These jacks are not suitable for use as wheel dollys, lifting or
levelling mobile, modular homes, construction trailers and dwellings in general. These jacks are for lifting one
side or end of a vehicle only.
Jack Model: 29023 Low Profile Jack
Rated Capacity: 2 Ton
Minimum Height: 63 mm
Maximum Height: 508 mm
Conforms to EN1494:2000 Standards
STUDY, UNDERSTAND, AND FOLLOW ALL
INSTRUCTIONS BEFORE OPERATING THIS
DEVICE. DO NOT EXCEED RA TED CAPACITY USE
ONLY ON HARD, LEVEL SURFACE. LIFTING
DEVICE ONLY. IMMEDIATELY AFTER LIFTING,
TRANSFER LOAD TO APPROPRIATELY RATED
JACK STANDS. DO NOT MOVE OR DOLLY LOAD
WHILE ON JACK.
LIFT ONLY ON THOSE AREAS OF THE VEHICLE
AS RECOMMENDED BY THE VEHICLE
MANUFACTURER. NO ALTERATIONS SHALL BE
MADE TO THIS PRODUCT. USE ONLY THOSE
ADAPTORS/ATTACHMENTS SUPPLIED BY THE
MANUFACTURER. FAILURE TO HEED THESE
MARKINGS MAY RESULT IN INJURY AND/OR
PROPERTY DAMAGE.
Figure 1 - Model 29023
GB
WARNING
!
!
U.S. Pat 5,755,099 6,199,379B1 5,946,912
EPC Patent No.: 0841299
