- Segment conveyor-page 6.1
Maintenance & setting
6.
6.
6.1 Wear and spare parts
Defective machine parts should be replaced as soon as possible. Please use the spare parts list
enclosed in the attachment to identify required spare and wear parts.
Only original parts or parts with equivalent quality maybe used for parts replacement.
6.2 Inspection
As needed:
Cleaning of the sliding surfaces of the segment conveyor with a cloth and, if needed, an
appropriate cleaning agent by briefed personnel. The cleaning cycle (frequency) may vary
depending on used product parts and must be practically determined.
Monthly
Check transitions between segment and feeding rail and between feeding rail and separator for
offsets or gaps. Adjust if necessary.
Check transducers for tight fit. Adjust if necessary.
Quarterly:
Clean system with cloth. Empty the parts container. Check separator, output rail, blade and part
container including its surface coating for damage.
Check pneumatics for leaks. If necessary, replace faulty parts.
All time intervals provided above, are calculated for average parts and average operating times. If
the mentioned time setup does not provide the desired effect, then it should be adjusted to your
actual production.
WARNING
