USER MANUAL - OPTIMA RT10 1K/1.5K/2K/3K (UL)
VER.2010.22-One (ENG)
19
10.
SOFTWARE
Our monitoring software allows user to manage UPS and monitoring of all of its features.
Main software features are: Configuring UPS parameters, Automatic shutdown for protected PCs (OS and files) when long blackouts
force UPS to power-off, Scheduled battery tests, shutdown and start-up and Easy interface for monitoring UPS and Main service.
CD software is usually included inside the box. For some models, software can be downloaded from our website. Software manual can
be downloaded from our website also.
11.
BATTERIES: CARE AND REPLACEMENT
To have a longer Battery life, it is recommended to apply a deep discharge to batteries every 3 months. It is also recommendable to
operate UPS with a room temperature below 25ºC. Operating UPS with higher room temperatures will short dramatically battery life.
IMPORTANT: RECHARGING PLAN FOR LONG STORAGE
If UPS will be stored for long time, it is mandatory to recharge UPS periodically. If UPS is not recharged according to this plan, batteries
will get permanent damage. This kind of damage is not covered by warranty.
STORAGE TEMPERATURE: - 25ºC to + 30ºC : RECHARGE EVERY 4 MONTHS / RECHARGE DURING 6 HOURS
STORAGE TEMPERATURE: + 30ºC to + 45ºC : RECHARGE EVERY 2 MONTHS / RECHARGE DURING 6 HOURS
This UPS series allows an easy and safety battery pack replacement as described below. Batteries can be replaced with UPS working in
ONLINE mode (hot swap batteries). Check details for step 3 for each model.
BATTERY REPLACEMENT
Batteries can be replacement in ONLINE mode following this procedure.
IMPORTANT:
If during replacement AC main service fails, UPS will turn off.
Batteries must be disposed according to your country regulations. Do not dispose batteries in fire as they might explode. Do not try to
open batteries, there are dangerous liquids inside.
1:
Remove front panel & disconnect batteries
2:
Remove Battery pack
3:
Replace old batteries by new batteries
(same technology, voltage and capacity).
4:
Insert Battery pack
5:
Connect Battery pack to UPS
6:
Install front panel.
