SW-PRO 800/1100/1600/2200VA
www.xmart-ups.com
VER. 2210.03-IM
3
3.
PRODUCT DESCRIPTION
SW-PRO 800/1100/1600/2000 series offers 4 different UPS models, all of them interactive type with internal automatic
voltage regulation and sinewave output in battery mode.
4.
INSTALLATION
TO MAKE SURE UPS WILL BE ABLE TO OFFER YOU EXPECTED BACKUP, FIRST TIME PLUG
UPS TO AC SOURCE DURING 4 TO 6 HOURS TO ALLOW RECHARGING INTERNAL BATTERIES.
•
This UPS leaves factory with battery fully charged, however during transportation and storage it may lose a non
determined part of its charge; therefore, we recommend plugging it to Power Line for 6 hours before using the UPS.
•
Install this unit in any protected environment with a dust free air flow. Also, corrosive vapours and conductive
contaminants must be avoided. Do not use UPS outdoors or where either temperature or humidity exceeds tech
specs. Install UPS at least 10 inches away from your monitor to avoid magnetic interference.
•
Connect phone or LAN cable to RJ11/45 Jack Identified as “IN” and your Router or PC RJ45 port to RJ
-11/45
Jack Identified as “OUT”. Plug UPS to a power outlet with a proper grounding. Connect your equipments to UPS
power outlets.
•
NEVER connect equipments with power consumption higher than Power Capacity of this UPS, such as Laser
Printers or copiers.
•
This unit MUST NOT be installed into closed boxes/cabinets that avoid fresh air access. During normal operation,
this unit needs fresh air to flow through ventilation system (Vents) to cool power circuits. Installing this unit in a
closed box/cabinet makes inner air to be recycled without refreshing, increasing inside temperature, exceeding
operation max. temperature, and causing permanent damage to the UPS.
THIS KIND OF UPS IS NOT COMPATIBLE WITH GENERATOR POWER PLANTS. DO NOT
CONNECT TO ELECTRICAL SUORCE SUPPLIED BY GENERATOR POWER PLANTS SINCE UPS
WILL NOT WORK PROPERLY.
