Remote:
• Output: RF signal
• Working Voltage: 4.5V
(3 x AAA battery / Not included)
• Working Frequency: 868/915/434MHz
• Remote Distance: 20~30 metres
• IP Rating: IP20
• Working Temp.: 0ºC~40ºC
• Relative humidity: 8%~80%
• Remote Dimensions: L120×W48×H17.6(mm)
• Weight(N.W.): 70g
3. Operating Instruction for Receiver
The Remote control has been matched to the receiver before leaving the factory, if deleted accidentally you
can restore the matching as follows.
RF Code Key: Switch on the remote. And short press the RF Code Key on the receiver, then immediately
touch the colour wheel on the remote. When the LED strips connected to the receiver flicker, the remote and
receiver are now matched and activated.
Note: One receiver can be matched to up to 8 remote controls.
Multiple receivers can be matched to one remote.
Cancel the matching: Press RF Code Key on the receiver for more than 3 seconds until the LED strips
connected to the receiver flicker.
MASTER/SLAVE jumper:
In a group of multiple receivers, in order to get a good sync of RGB running effect, please set ONLY ONE
receiver as MASTER, the other receivers as SLAVE.
After the Master is set, switch off the Master receiver and then switch on, to activate the Master function.
RF code key: pair with the RF remote
V+ Output (+)
CH 1: R output (-)
CH 2: G output (-)
CH 4: W output (-)
CH 3: B output (-)
DC Power input
MASTER/SLAVE jumper
RF code key
RGBW RF LED Receiver
V+
V-
INPU
T
V+
R-
G-
B-
OUTPUT
W-
Total Weight (G.W.): 185g
