Preliminary Steps
- 6 -
Install the external earset-microphone jack rubber cover.
If an external earset-microphone (or the programming cable) is not used,
please install the earset-microphone jack rubber cover.
Install the earset-microphone jack rubber cover, by matching the three
rubber tabs with the holes on the radio, as showed on the drawing.
If the earset-microphone jack rubber cover is removed, radio will not be
splash proof.
To install the external microphone (optional)
To install the external microphone, remove the protection cover of the
external microphone/speaker jack. This cover ensures the watertight
integrity of the transceiver (spray-guard) that will not be ensured after its
removing. Insert the connector of the external microphone into the
right jack.
In order to avoid mulfunction or damage to the transceiver, use only
original microphones. Using non original accessories will authomatically
void the warranty.
Warning !
If an external earset-microphone is used, radio will not be splash proof.
Installing the antenna (only for models MT-174ET and MT-460ET)
Connect the antenna to the antenna connector located on the top panel of
the radio. Gently turn the antenna clockwise until locked.
Warning :
Do not touch the antenna and do not move it close to a
microphone cable during transmission, as this might cause malfunction
and damage to the radio.
(FOR MODEL MT-446ET)
WARNING !
THE RUBBER FLEXIBLE ANTENNA IS FIXED AND NOT REMOVABLE.
DO NOT TRY TO TURN OR REMOVE IT, OTHERWISE ANTENNA MAY
BE BROKEN.
English
Summary of Contents for ET Series
Page 36: ......
