Working Inside the System
21
Installing Server Board Clips and Bumpers
To support the server board in the Astor II chassis, you must install three rubber bumpers and
eleven or twelve standoff clips (depending on the server board you are installing).
1.
Peel the adhesive backing from three rubber bumpers; stick the bumpers to the chassis wall
(see Figure 9, A).
2.
Install eleven or twelve standoff clips in the chassis wall (see Figure 9, B). Gently pinch the
open end of each clip with needle-nosed pliers, insert into a slot on the chassis wall, and
release. Pressure holds the clip in place.
OM07019
4.5"
6.0"
3.0"
10.0"
7.75"
A
B
Figure 9. Rubber Bumper and Standoff Clip Placement
B.
Rubber bumper
C.
Standoff clip location
