56
Intel Astor II Server Chassis Subassembly Product Guide
Use Only for Intended Applications
This product was evaluated as Information Technology Equipment (ITE) that may be installed in
offices, homes, schools, computer rooms and similar locations. The suitability of this product for
other Product Categories and Environments other than ITE applications, (such as medical,
industrial, alarm systems, and test equipment) may require further evaluation.
When you integrate this subassembly, observe all warnings and cautions in the Installation Guide.
To avoid injury, be careful of:
Sharp pins on connectors
Sharp pins on printed circuit assemblies
Rough edges and sharp corners on the chassis
Hot components (like processors, voltage regulators, and heat sinks)
Damage to wires that could cause a short circuit
WARNING
Do not open the power supply. Risk of electric shock and burns from
high voltage and rapid overheating. Refer servicing of the power supply
to qualified technical personnel.
To maintain the UL listing and compliance to other regulatory certifications and/or declarations,
the following regulated components must be used, and conditions adhered to. Information for
system configurations can be found through Intel’s web address (http://www.intel.com). If you do
not have access to Intel’s web address please contact your local Intel representative.
Astor II chassis (chassis is provided with power supply and fans)UL listed.
Server boardyou must use an Intel UL Recognized Server board.
Add-in boardsmust have a printed wiring board flammability rating of minimum UL94V-1.
Add-in boards containing external power connectors and/or lithium batteries must be UL
Recognized or UL Listed. Add-in boards containing modem telecommunication circuitry must
be UL Listed.
Peripheral storage devicesmust be UL recognized or UL listed accessory and TUV or VDE
licensed. Maximum capacity for this chassis is 8 devices; maximum of any one device is
17W. Total system configuration is not to exceed maximum loading conditions of power
supply.
When using a UL Recognized Peripheral Storage Device, the plastic bezel must be made
of a UL recognized plastic with a flammability rating of 5V.
