5
WARNING: Turn off and unplug power to the computer before installing the
WOL cable. The WOL connector on your motherboard is live when the com-
puter is plugged in to a power outlet. Failure to do so could damage the
adapter or computer. Likewise, always turn off and unplug the computer prior
to removing an adapter from the computer.
1
Make sure your computer is unplugged from the power outlet.
2
Locate the 3-pin WOL connector on the adapter. Attach one end of the
WOL cable to the adapter as shown in the diagram that follows.
Note that the connector is notched so as to prevent incorrect attachment.
3
Locate the WOL connector on your motherboard. The location varies,
depending on the vendor and model of motherboard. The WOL connector
is usually located near other power connectors, such as the LED
connectors.
4
Connect the other end of the WOL cable to the connector on the mother-
board as shown in the diagram.
5
Some computers may require you to change a setting in your computer’s
BIOS or Setup program to enable the WOL feature. Check your computer
owner’s manual or contact your dealer for more information.
6
Replace the computer cover and plug in the power cord.
7
See the section on using Wake on LAN below, then continue to the section
Configure the Adapter and Install the Drivers.
PC-3920
Wake on LAN cable
Note: Your specific adapter
model may differ from
that shown.