Intel P4000CR, Installation Instructions Manual

8

General Installation Process

A
B

C

5

Install Heat Sink(s)

Get heat sink from the shipping position.

A

Remove the protective film on the TIM if present.

E

D

B

C

Securely re-tighten each fastener again in the same order as performed in Step D.

Using a #2 Phillips* screwdriver, finger-tighten each fastener diagonally, 

according to the numbers shown.

Align heat sink fins to the front and back of the chassis for correct airflow.  

Airflow goes from front-to-back of chassis.

The heat sink has four captive fasteners and should be tightened using the following procedure:

CAUTION: The heat sink has thermal interface 

material (TIM) on the underside of it.  Use caution so 

that you do not damage the thermal interface material. 

Use gloves to avoid sharp edges.

C

TIM

Processor

Soc

ket

AIRFLOW

B

2

3

1

4

Chassis Front

D E

CAUTION:

Do not 

over-tighten

fasteners.

Fan Kit

(Only available 

for W2600CR)

Install the Processor(s) ... 

continued

C.   Install the Processor

Take the processor out of the box and remove the protective shipping cover.

CAUTION: When unpacking a 

processor, hold by the edges only to 

avoid touching the gold contact pins.

Save the 

protective 

cover.

A

CAUTION: The underside of the processor has

             components that may damage the socket pins

if installed improperly.

Processor must align correctly with the socket opening before installation.  

DO NOT DROP

 processor into socket!

Components

Note location of gold key at corner of processor.

Orient the processor with the socket so that the processor cutouts match the four orientation 

posts on the socket.

B

C

Install the Processor(s) ... 

continued

D.   Remove the Cover

Press the cover to

remove it.

Carefully lower the load plate over

the processor.

E.   Close the Load Plate

Push down on the locking lever on the close 1st side.

F.  Latch the Locking Lever

A

B

Slide the tip of the lever under the notch in the load plate.  

Make sure 

the load plate tab engages under the socket lever when fully closed.

C

Repeat the steps to latch the locking lever on the other side.

NOTE: Latch 

the levers in the 

order as shown.

Save the 

protective 

cover.

FOXCONN  LGA201

1  ILM  17562

B

A

C