Intel®
Server Board S1200V3RP TPS
Jumper Blocks
Revision 1.2
203
1. After downloading the latest System Update Package (SUP) from the Intel
®
website,
copy the following files to the root directory of a USB media device:
-
IPMI.EFI
-
IFlash32.EFI
-
RML.ROM
-
####REC.CAP (where #### = BIOS revision number)
-
STARTUP.NSH
2. Power OFF the system
3. Locate the BIOS Recovery Jumper on the server board and move the jumper block from
pins 1-2 (default) to pins 2-3 (recovery setting)
4. Insert the recovery media into a USB port
5. Power ON the system
6. The system will automatically boot into the embedded EFI Shell
7. The STARTUP.NSH file automatically executes and initiates the flash update. When
complete, the IFlash utility will display a message
8. Power OFF the system and return the BIOS Recovery jumper to its default position
9. Power ON the system
10. Do *NOT* interrupt the BIOS POST during the first boot.
11. Configure desired BIOS settings
10.3
Password Clear Jumper Block
This jumper causes both the User password and the Administrator password to be cleared if
they were set. The operator should be aware that this creates a security gap until passwords
have been installed again through the BIOS Setup utility. This is the only method by which the
Administrator and User passwords can be cleared unconditionally. Other than this jumper,
passwords can only be set or cleared by changing them explicitly in BIOS Setup or by similar
means. No method of resetting BIOS configuration settings to default values will affect either the
Administrator or User passwords.
1. Power down the server and unplug the power cords.
2. Open the chassis and remove the Riser #2 assembly.
3. Move jumper from the default (pins 1 and 2) operating position to the password clear
position (pins 2 and 3).
4. Close the server chassis and reattach the power cords.
5. Power up the server and wait until POST completes.
Summary of Contents for S1200V3RP
Page 14: ......
