8
© Intel
2
Software
Note:
This chapter describes the IT requirements for the Intel® Shooting Star Mini™ system.
2.1 IT Requirements
In order to use the Intel® Shooting Star Mini™ system, the operator must provide basic IT
equipment, such as a PC with the Windows 10 operating system. An uninterrupted power supply,
which protects the PC from a power surges and outages, is also recommended.
Table 2-1. Hardware Requirements
Component
Minimum
Recommended
Processor
64-bit Dual-Core
64-bit Quad-Core
Memory
8GB
16GB
Hard Drive
200GB
500GB
Screen
1920x1080
1920x1080 (touch sensitive)
Table 2-2. Software Requirements
Component
Minimum
Recommended
OS
Windows 10 64-bit
Windows 10 64-bit
Framework
Microsoft Visual C++ 2017 Redistributable
2.2
ILT Configuration
The ILT network is needed in order for Control Center to communicate to the Drones. This
communication link can be established via Ethernet once the ILT network has been configured.
1.
Plug in and turn on the Network Server and then attach the sniffer device using a USB cable
that is no more than 5 meters long.
2.
Plug in and turn on the Computer and connect it to the Intel NUC using an Ethernet cable that
is no more than 100 meters long.
3.
Open the ILT Network Manager. The first time you open this application, it will prompt you to
add the IP address and serial port for the network. After that, the application will default to
the saved network settings and automatically detect and map the anchors that are powered
on in the room. This configuration can be changed by clicking on “System Config” in the Menu.
After a few minutes, the network will automatically detect and display the location of all
anchors in the GUI tab.
4.
You will need to examine the monitoring page and click on the red anchor and link cards, to
view recommendations for optimizing the network set-up.
