Intel® Server System SR2500AL
1BPower
Sub-System
Revision – 1.6
Intel order number D31980-009
13
2.5 Airflow
Each power supply module incorporates two non-redundant 40mm fans for self cooling and
partial system cooling. The fans will provide no less than
10 CFM
airflow through the power
supply when installed in the system and operating at maximum fan speed. The cooling air will
enter the power module from the PDB side (pre-heated air from the system).
2.6 AC Power Cord Specification Requirements
The AC power cord used must meet the following specification requirements:
Cable Type
SJT
Wire Size
16 AWG
Temperature Rating
105º C
Amperage Rating
13A
Voltage Rating
125V
2.7 Output Cable Harness
The power distribution board provides a cable harness providing connectors to the various
system boards. The harness size, connectors, and pin outs are shown below. Listed or
recognized component appliance wiring material (AVLV2), CN, rated 105
°
C min, 300Vdc min
shall be used for all output wiring.
Table 2. Power Harness Cable Definitions
Length
mm
To
connector #
No of
pins
Description
90, 90°
angle
P1
2x12
Main Power Connector
115, 90°
angle
P2
2x4
Processor Power Connector
100
P3
1x5
Server Board Signal Connector
150
P4
2x4
Backplane Power Connector
220
P5
2x5
Mid-plane Power Connector
Summary of Contents for SR1500 - AXXMINIDIMM DDR-2 RAID Controller Cache Memory
Page 12: ......