The Installation Steps
4
Intel® PRO/Wireless 2011B LAN Access Point Quick Installation Guide
Mount the Access Point
Access point coverage is similar to lighting in that an area lit
from far away might not be bright enough. Uniform access
point placement provides even, efficient coverage. Position
each access point using the following guidelines:
•
Install the access point as high as practical.
•
Orient the access point’s antenna vertically for best
reception.
Decide how you want to mount the access point. There are
three options.
•
Resting the access point flat
•
Attaching the access point to a wall
•
Mounting the access point to the ceiling grid
If you are resting the access point flat, it rests on four rubber
pads on its underside. Place on a surface clear of debris and
away from office traffic.
If you are attaching the access point to a wall, use the mounting
kit provided.
Position the Antennas
The access point contains a dual antenna assembly providing
diversity, improved performance, and increased signal strength
over single antenna applications. If the access point is attached
to the ceiling, point the antennas downward.
Connect the Network
Locate the connector for Ethernet on the back of the access
point. Plug the 10/100Base-T Ethernet cable into the
connector. Ethernet configurations vary according to the
environment.
If you are connecting the access point to a hub, connect the
access point to a wired UTP Ethernet hub. Normal 10Base-T
limitations apply.
If you are connecting the access point to an Ethernet switch,
ensure that the switch port parameters are set to 10 Mbps Half
Duplex. Severe performance degradation may result from
mismatched speed or duplex mode.
