81
32.3 Remove caller ID category
This will allow you to remove the subscriber´s category in case your equipment cannot
distinguish between the category and number and therefore is not able to redial the
phone number.
An extension with caller ID enbaled can display external or internal incoming call
numbers.
Example: Extension 20, with caller ID enabled, receives a call from extension 22. The
telephone displays will show the extension number preceeded by the category (9 by
default): 9 22
Please follow the below steps to program the feature:
To activate call classification (Caller ID category)
From main extension, lift handset (off-hook), press 12 + MAIN PASSWORD (3 digits) +
3021, wait for programming prompt.
To cancel
From main extension, lift handset (off-hook), press 12 + MAIN PASSWORD (3 digits) +
3020, wait for programming prompt.
Note: The above applies to all extensions.
32.4 Received call classification for the Ti (KTS)
Factory setting: No registration for received call classification.
This allows the PABX to identify the classification of the type of call received along with
the phone number.
Call type registration will be done as follows:
Categ. 0
(Ignored source - error);
1 - Reg. Subs
(regular subscriber);
2 - Spec. Rate
(subscriber with special rates);
3 - Maint.
(equipment maintenance);
4 - Local
PT (local public telephone);
5 - Operator
(operator);
6 - Fax/Modem
(data equipment);
7 - PT DDD
(Public telephone domestic);
8 - Coll. call
(collect call).
Activating the reception of call classification
Lift the main extension handset, press
+
MAIN PA
,
This classification is
displayed in the
TI630i or in the
ecall report.
