82
wait for confirmation tone.
Desactivating
Lift the main extension handset, press
+ MAIN PA
,
wait for confirmation tone.
32.5 Prefix DDD/Area code for Ti
Factory setting: No prefix programmed.
This is necessary for the use of caller ID in the TI 630i. When programming, the zero
(0) should not be entered, as example, of the area code is 048, just enter 73 + 48.
Programming the prefix DDD/Area code
Lift the main extension handset, press
+ MAIN PASSWORD +
+
AREA CODE (PABX location), wait for confirmation tone.
Desactivating the prefix DDD
Lift the main extension handset, press
+ MAIN PA
, wait
for confirmation tone.
Desactivation the access to answering machine
Lift the main extension handset, press
+ MAIN PA
+
+
EXTENSION Nº, wait for confirmation tone.
33. ELECTRONIC DOORPHONE
Note
- If you install a PI 100 and replace it by another doorphone that requires an interface
(IP 700), you should desactivate the installation, and then follow the steps in 34.3.
Once the new doorphone is installed, program its physical position as in 34.2;
- If the above is reversed (replace a third part doorphone with a PI 100), you should
follow the steps in 34.1;
- No programming is required if you want to replace a third part doorphone by another
third part doorphone.
For a proper operation of the dorphone:
- Program the physical position of the doorphone. See 34.1 or 34.2;
- Program the extension accessing the doorphone. See 34.4;
- Program an extension and/or external number as doorphone attendant. See 34.5
and 34.6;
For this feature
function properly,
you should request
your carrier to
provide you with
the subscriber´s
category to be
registered by the
PABX.
