-4-
+12V
LK - (GND)
LK+(COM)
N.O.
EB+
EB -
Set Unlock Relay mode to
Normally Closed(1)
+
+
-
-
Note: Cut off this line when
using external power supply
D. Connection for Power--off-to-Unlock type:
5. Functions Setup
This section explains the settings of each parameter,please refer to the following table:
About the setting mode:
Input the master code to enter the setting mode, and input the corresponding setting code to perform the settings
for the function you want. After settings have been made, input the following setting codes to continue the setting
operation. Press " " to exit the setting mode.
•
The example is set
as cancel button and # as confirm button, please refer to */# function
setting for detail information.
•
Forbid sliding touch to the digital keypad, it may cause mistaken key, the correct operation is
using your finger to press the digital you desired.
• You should press“confirm”button after finish inputting the code number each time, otherwise,
the operation will be canceled automatically after 10s.
Order
Setting items
Setting code
Setting range
Default value
1
Reset all settings
00
-
1,2,3,4
2
Set master code
01
1 ~ 12 digits
Valid keys:0 ~ 9
1234
3
Set digitron display
mode(in standby mode)
02
Valid keys:0 ~ 2
0
5.1 Setting Items and Codes
