Intellinet 500517, User Manual

Federal Communication Commission 

Interference Statement 

This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of FCC Rules.    These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful 
interference to radio communications.    However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:     
 

1.  Reorient or relocate the receiving antenna. 

2.  Increase the separation between the equipment and receiver. 

3.  Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

4.  Consult the dealer or an experienced radio technician for help. 

FCC Caution

This device and its antenna must not be co-located or operating in conjunction with 
any other antenna or transmitter. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and (2) 
this device must accept any interference received, including interference that may 
cause undesired operation. 
  
Any changes or modifications not expressly approved by the party responsible for 
compliance could void the authority to operate equipment. 
 

Federal Communications Commission (FCC) Radiation Exposure Statement 

This equipment complies with FCC radiation exposure set forth for an 
uncontrolled environment. In order to avoid the possibility of exceeding the 
FCC radio frequency exposure limits, human proximity to the antenna shall not 
be less than 2.5cm (1 inch) during normal operation.