49
length and “Hex” as key format, you’ll see the
message at the right of “Key Format” is “Hex
(10 characters,” which means the length of the
WEP key is 10 characters.
Default Tx Key
You can set up to four sets of WEP keys, and
you can decide which key is being used by
default here.
If you don’t know which one
you should use, select “Key 1.”
Encryption Key 1
to 4
Input WEP key characters here. The number
of characters must be the same as the number
displayed in the “Key Format” field. You can
use any alphanumerical characters (0-9, a-z
and A-Z) if you select “ASCII” key format; if
you select “Hex” as the key format, you can
use characters 0-9, a-f and A-F. You must
enter at least one encryption key here; if you
enter multiple WEP keys, they should all be
different.
Enable 802.1x
Authentication
Check to enable 802.1x user authentication.
Refer to Section 2-7-5 for detailed instructions.
After you finish with the settings, click “Apply” and the following
message will be displayed:
When you see this message, the settings you made are
successfully saved. Click “Continue” to go back to the previous
page and continue with other settings, or click “Apply” to restart the
wireless access point. Changes will take effect after about 30
seconds.
Summary of Contents for 524728
Page 22: ...16 ...
