Intellipure 10600-9, User Manual

7

Operation  |  Function Description

Power On/Off  and Speed Control

1. Plug the unit into a 100-240V, 50-60Hz power outlet. Unit goes on standby mode. 

2. Press POWER button, the unit starts operation on low speed. Speed indicator LOW is lit in blue.

3. Press the POWER button to change speed. Speed change once at a time from Low, Medium, High to Turbo.  

Turbo mode is the highest speed and is designed for a short-term speed cleaning. 

4. After going through all four speeds, the unit turns off and goes back to standby mode. 

Sleep Mode

1. When unit is on standby mode, press the POWER button to turn unit on. 

2. Adjust the unit to desired speed.

3. Sleep mode is activated automatically after 60 seconds. No need to press any button. All indicators on the control panel dim down.  

Unit will stay in desired speed. 

4. To deactivate sleep mode, press the POWER button once. The indicators light up in bright blue. 

5. Change speed, or turn unit off when sleep mode is deactivated. 
6. Unit automatically goes back to sleep mode again after 60 seconds. 

Main Filter Replacement

1. When unit is under  normal operation, DFS function is turned on by default. The DFS indicator is lit in blue. 

2. When the DFS indicator flashes, DFS grid needs to be cleaned and the main filter needs to be replaced.

3. Replace the main filter and reset the timer to reactivate DFS function.  

4. Press and hold the POWER button for 5 seconds to reset timer. DFS indicator quickly flashes 3 times and timer is reset.  

Timer can be reset when sleep mode is activated and deactivated. 

WARNING: The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of 

experience and knowledge, unless supervised or they have been given instruction.

This product complies with the maximum allowable concentration of ozone of 0.050 parts per million by volume (ppmv)  

in a 24-hour period. The Health Canada Guideline 2010 recommends that the maximum exposure limit, based on an averaging  

time of 8 hours, is 0.020 ppmv or less when tested in a sealed, controlled room approximately 30 m3.