6
4. Y-MOTOR
Mount the Y-motor on the front left wheel support as Fig. 6 shows. Set the drive and
sensor wheels in the middle of the outer surface of the plastic rail and tighten the
two bolts, but do not overtighten them.
Fig. 6
Set the motor assembly's position utilizing the slots on the brackets, so both the
drive roller and sensor wheel run in the middle of the track. There should be a 1/16"
gap (about one credit card thickness) between the drive roller and the track when all
the screws are fully tightened. Move the drive roller and sensor wheel in/out to
achieve the best alignment.
.
For detailed installation, alignment and adjustment
instructions see the "SM-V3 Installation” and the “Motor Alignment
Procedure" documents.