23
22.
For spot temperature with its temperature value being measured in
real-time. While the camera is in the monitoring mode, maximum four spots can be
displayed with its temperature being shown respectively. Detailed description is as
following:
Example: Press button S2, and move the mouse onto the monitoring frame. Click on its
let key on the position you appointed, a spot with No. of 2 will be displayed, with its
temperature value being shown in the result table
23.
Draw the temperature line, displaying the temperature in real-time.
Only
one line can be drawn while the camera is in the monitoring mode, displaying its
temperature of midpoint.
Example: Press LH button and move the mouse onto the monitoring frame. Press the left
key of the mouse while moving it until to a certain position and release the key. The start
point of the line is where you start moving the mouse and its end point is where you
release the key. Its temperature of midpoint will be displayed in the result table.
24.
Area function, displaying its temperature value in real-time.
While the
camera is in the monitoring mode, maximum three areas are available, measuring either
the maximum or minimum temperature within a rectangular.
Example: Press button A2, and move the mouse onto the monitoring frame. Click on the
left key of the mouse while drawing it. A rectangular will be created marked as no. 2. Its
highest temperature or the lowest temperature will be indicated in the result table
.
25.
Click
Add
in pop-out menu can also add temperature measured.
5.3. System setting
Figure 5.7
