Manual Intend Stiffmaster - 5
Push the lower cup with the already
pressed in radial bearing onto the unit.
By pushing all together, the blue shell
comes out through the upper cup with.
Ensure a proper and smooth run of the
unit. If not, maybe the o-ring is anywhere
where he shouldn’t be. If you put in
everything correctly, you will feel a
smooth run of the headset in the
assembly step shown on the right side.
If the O-ring gets slightly damaged anywhere, this does NOT make a big influence of the
seal – don’t worry!
Press it in like shown left or use a device for this step e.g. a softhammer or a bench vice
(Schraubstock).
You are ready !
