32
6. MAINTENANCE
6.1
Preventative Maintenance Tips
With durable, high performance components, Intenza 550 series treadmill is designed for heavy usage with
minimal maintenance required. To keep your Intenza 550 series treadmill in safety level, Intenza strongly
recommends performing the regular daily and regularly preventative maintenance routines outlined below.
Daily maintenance
z
Locate the product in a dry, cool place.
z
Before and after each exercise session, ensure the area around Intenza 550 series treadmill is free of obstacles
and any clutter that may interfere with Intenza 550 series treadmill operation.
z
Remove excessive accumulations of dust, dirt, and other substances by using a clean, soft cloth and a
non-abrasive liquid cleaner. Wipe down the exterior of the console, stick shift, handlebars, and contact heart
rate grips.
z
Avoid getting extra moisture on the console. Keep the console free of fingerprints and sweat will extend the life
of
console.
z
Never use ammonia, acid-based, or petroleum-based solvents on any surface area of Intenza 550 series
treadmill as it may damage Intenza products.
Regularly maintenance
z
Inspect the console mounting screws for security, and retighten if necessary.
z
Inspect the display panel keypads for wear.
z
Check the belt tension of running belt and drive belt.
z
Check the position (centering) of the striding belt.
z
Check operation of the emergency stop system.
z
Inspect and vacuum the area directly surrounding and under the unit regularly to keep debris from
accumulating..
z
Check Intenza 550 series treadmill is well-leveled. All of its feet should be leveled to the floor, and should not
wobble when in use. If not, re-level the equipment.
6.2
How to Align the Running Belt
During running or walking, your left and right foot may exert different force to the running belt. This will cause the
running belt to run off centered. Intenza 550 series treadmill is designed and built to ensure proper belt tracking so
that it will automatically re-centered by itself. Occasionally the belt may need further adjustment to keep it centered.
To center the belt, use the enclosed T wrench to adjust the rear roller position.
Running belt centering procedure
1.
Never turn the bolts more than 1/4 turn at a time.
2.
Always tighten one side and loosen the other to prevent over tightening the belt.
3.
Turn on the treadmill. Adjust belt while the treadmill is running at 4 mph (6.4 kph) with no person on the
running
belt.
If belt is too far to the left side
1.
Turn the left roller bolt 1/4 turn clockwise (to tighten)
2.
Turn the right roller bolt 1/4 turn counterclockwise (to loosen)
If belt is too far to the right side
1.
Turn the right roller bolt 1/4 turn clockwise (tighten)
2.
Turn the left roller bolt 1/4 turn counterclockwise (loosen)
NOTE
1.
After the adjustment, walk on the belt for five minutes to test. If the belt still slips, repeat the procedure but never
turn the bolts more than 1/4 turn at a time. Over tightening the belt can significantly shorten the belt life.
2.
To reduce the risk of electrical shock, always unplug the treadmill from the electrical outlet after using and
before
cleaning.
3.
For Entertainment console, you should press the console power button to put the equipment into energy saving
mode first, then unplug the power cord or switch off the equipment.
Mainte
nanc
e
T
roub
le S
hooti
n
g
W
o
rk
out Option
Setup
Introductio
n
Saf
e
ty prec
auti
o
n
Assemb
ly
