TELEPHONE PAGING
10
TP-6231
- RING Number.
Determines the number of RINGs before the TP-6231 will answer when receiving a call.
- Operational Method Setup
Select from 2 possible operation modes as per table below:
※
DIP switches during operation, must not operated, press the RESET switch.
9. UNIT ADDRESS SETUP SWITCH
It is the switch which allocates the equipment number. (Input in hex. Value)
MSB
LSB
This switch is used when sending the equipment address number or status information via the RS232
communication port terminal (Connector 15 on rear panel).
※
[Reference] SERIAL OUT terminal. If used, remove the top cover and set the slide switch on the PCB board
(S7) to the RS-232 position.
10. LINE OUT GAIN VOLUME
Adjusts volume output level.
11. LINE OUTPUT TERMINAL
600
Ω
BALANCED OUTPUT.
12. 4 & 2 WIRE SELECTOR SWITCH
SELECTOR SLIDE switch selects between 4 & 2 WIRE operation mode.
13. TELEPHONE INTERFACE
RJ12 Connector. This terminal connects to the Telephone Line. Used for both 4 wire and 2 wire mode.
Pin 1 Mouth, Pin 2 Ground, Pin 3 Ring, Pin 4 Tip, Pin 5 Ear, Pin 6 -48V
14. RESET SWITCH
Status will be restored if normal operation.
5
6
RING 횟수
OFF
OFF
0
OFF
ON
1
ON
OFF
2
ON
ON
3
7
8
운용 방법
OFF
OFF
ALL 기능
ON
OFF
SECURITY 입력 생략
6*
7*
DIP 스위치
1
2
3
4
5
6
7
8
실제 값
8
4
2
1
8
4
2
1
예
OFF
OFF
ON
ON
OFF
ON
OFF
ON
결과
63
75