1. General
—
Scape®
Lab
Technical specifications are subject
sla65-004
to change without notice.
Operating Manual
Version 1.6 – Status: 11/2019
Page 4 of 20
poc: SFi
1.
General
This manual describes the safe installation, configuration and correct operation of the
Scape® Lab
.
If your device does not have an integrated PC, you can skip the chapters and notes about the integrated PC. All other
notes and instructions continue to apply without restriction.
If necessary, pay attention to the supplementary documents, such as the installation instructions.
1.1.
Safety instructions
Before using and operating your
Scape® Lab
, observe the following safety instructions to prevent you, your
environment or the
Scape® Lab
from being damaged.
Fire and electric shock
Overloaded sockets, extension cords and power strips can cause fire and electric shock.
·
Avoid using power strips and extension cords if possible.
·
Do not chain multiple extension cords or power strips together.
Overheating
Heat build-up can overheat the screen and the integrated PC. This can damage the device.
·
Ensure there is sufficient air circulation around the
Scape® Lab
.
·
Make sure all the ventilation holes on around the screen and integrated PC are uncovered.
Excess voltage from lightning strikes
In the event of a thunderstorm there is a risk of excess voltage damage from lightning strikes electrical appliances that
are plugged in.
·
Do not install the Scape® Lab during a thunderstorm.
·
Disconnect the devices from the mains during thunderstorms.
Moisture, liquid and steam
Moisture, liquid and steam inside the
Scape® Lab
can cause electric shocks or short circuits.
·
Only use the
Scape® Lab
indoors.
·
Do not allow liquids to get inside the
Scape® Lab
.
·
Protect your
Scape® Lab
from steam and moisture.
