Output
Syntax
Command
Description
Return Value
Output <number> [<range...>]
Select one or more outputs
The state of the
selected output(s)
Output <station>.<number> [<range...>]
Select one or more outputs on a
specific station
The state of the
selected output(s)
Output ?
Return the current selection
A selection string
Abbreviation
O
Description
Selecting Outputs
The
Output
command selects one or more outputs in the system. Outputs are typically the hard-wired digital
outputs on a CueServer or external I/O board. Use the
Output
command in conjunction with an action
command like
,
, or
to change the output state of one or more outputs. When used alone or in logic
expressions, the
Output
command returns the current state of the specified output(s).
Either a single output number can be specified, or a range of outputs can be specified using the various
like +, -, > and ~.
The wildcard character
*
can be used as the output number to mean
all
outputs for a particular station.
Working With Stations
When no station number specified, the default station is assumed. The
command can be used to
change the default station. Unless changed by the
command, the default station is typically Station
0, which corresponds to the built-in outputs on the CueServer itself. When a station number is specified as
part of the
Output
command, that station number will be used for the selection.
Interactive Technologies, Inc.
CueServer 2 User's Manual - 18.5.18
Page 162 of 429
