Step 1
Open the battery cover at the back of
the IR Controller by removing the screw.
Be sure to install the batteries
in the correct orientation
(as shown).Insert six (6) new
AA batteries*
Use only alkaline batteries.
Replace the battery
cover and secure by
tightening the screw.
FOR BEST PERFOR
MANCE ONLY USE NEW
ALKALINE BATTERIES,
DO NOT MIX OLD AND NEW
BATTERIES.
Step 2
Open the charger cover at the side of the IR
Controller. Locate the charge cable and
extend it out (as shown)
The IR Controller also works as the charger
for the Black Ghost which has its own internal
rechargeable battery.
CHARGING YOUR BLACK GHOST HELICOPTER
Step 3
1) Ensure the helicopter's
Red LED is ON:
Power switch in "ON" position.
Green LED is OFF:
The helicopter is fully charged.
Red LED rapid flashing:
After the controller Initialized.
Green LED is ON:
PILOT INFORMATION NOTICE!
PILOT INFORMATION NOTICE!
* Batteries are sold separately
TM
TM
