15 Ga. Angled Finish Nailer
Drives 34˚ Finish Nails (1-1/4" to 2-1/2" / 32 to 65mm)
Model No. NF6515-34
Item No. 65420
11
Interchange Brands
Operator’s Manual
WARNING
NEVER connect nailer to pressure which potentially
exceeds 150 psi.
DO NOT USE THE WRONG FITTING ON NAILER.
The nailer and air hose must have a hose coupler so that
all pressure is removed from the nailer when the coupler is
disconnected . The connector on the tool must not hold pressure
when the air supply is disconnected . If the wrong fitting is
used, the tool can remain charged with air after disconnecting
and thus will be able to drive a nail even after the air line is
disconnected, possibly causing injury .
DANGER
NEVER use oxygen or other bottled gases, as an
explosion may occur.
!
!
3.
AIR HOSE
Air hose must have a minimum working pressure rating of 150 psi or 150% of the
maximum pressure produced in the system, whichever is higher .
Operating Pressure
1.
OPERATING PRESSURE
Recommended operating pressure is 70 to 120 psi / 5 to 8 .5 kgs .
Select the operating pressure within this range for the best fastener
performance . The nail length and thickness and the hardness of the wood
are factors in determining what the pressure should be set at .
Do not exceed this recommended operating pressure .
Lubrication
It is important that the tool be properly lubricated . Without proper lubrication, the tool
will not work properly and parts will wear prematurely .
Use INTERCHANGE pneumatic tool lubricant . Do not use detergent oil or
additives . These lubricants will harm the O-rings and other rubber parts . This
will cause the tool to malfunction .
Filter-regulator-lubricator units should always be used . Keep the lubricator
filled with INTERCHANGE pneumatic tool lubricant .
If a lubricator is not available, supply 3 to 5 drops of INTERCHANGE
pneumatic tool lubricant into the air plug on the tool twice a day .
NOtE:
Dirt and water in the air supply are major causes of wear in the tool . An air
filter will help to get the best performance and minimum wear from the tool .
Frequent, but not excessive, lubrication is required for the best performance . Oil added
through the air line connection will lubricate the internal parts .
