15 Ga. Angled Finish Nailer
Drives 34˚ Finish Nails (1-1/4" to 2-1/2" / 32 to 65mm)
Model No. NF6515-34
Item No. 65420
12
Interchange Brands
Operator’s Manual
Testing The Nailer
1.
Disconnect air hose from nailer .
Remove all nails from nailer .
ALL SCREWS MUST BE TIGHTENED.
If any screws are loose, tighten them .
THE SAFETY/PUSH LEVER AND
TRIGGER MUST MOVE SMOOTHLY.
2.
Adjust the air pressure to 70 psi .
Connect the air hose .
Do not load any nails in the nailer .
Set the switching device to the
upward position ﹙single actuation
mechanism﹚ completely as shown
in the diagram otherwise it will not
operate properly .
THE NAILER MUST NOT LEAK AIR.
3.
Remove the finger from the trigger
and press the safety/push lever
against the wood .
THE NAILER MUST NOT OPERATE.
Depress
Push
Lever/
Safety
Push
Lever/
Safety
Before using the nailer, test it by using the check list below .
Conduct the test in the following order .
If abnormal tests occur, stop using the nailer and contact an authorized service center
immediately .
