15 Ga. Angled Finish Nailer
Drives 34˚ Finish Nails (1-1/4" to 2-1/2" / 32 to 65mm)
Model No. NF6515-34
Item No. 65420
13
Interchange Brands
Operator’s Manual
4.
Separate the safety/push lever from
the wood .
Next, point the nailer downward,
pull the trigger and then wait in that
position for 5 seconds or longer .
THE NAILER MUST NOT OPERATE.
5.
Without touching the trigger, depress
the safety/push lever against the work
piece .
Pull the trigger .
THE NAILER MUST OPERATE.
Hold the trigger back while separating
the safety/push lever from the wood .
THE NAILER WILL REMAIN
OPERATIONAL ﹙the driver blade will
remain at the bottom﹚ .
Remove the finger from the trigger .
NAILER OPERATION WILL END ﹙the
driver blade will return to the top﹚ .
6.
Set the switching device to the
downward position ﹙bump fire﹚
completely as shown in the diagram
otherwise it will not operate properly .
With the nailer off the work piece, pull
the trigger .
Depress the safety/push lever against
the work piece .
THE NAILER MUST OPERATE.