IMD-300 Quick Installation Guide
Copyright
©
InterEdge Technologies, LLC. All Rights Reserved.
IMD-300 QIG Rev. 1.0-081505
1
Connect the ITA-200
A
Before you begin, make sure that you have
the setup information for your specific type of
internet connection.
B
Make sure that all of your network’s
hardware is powered off, including PCs,
IMD-300, and cable or ADSL modem.
C
Connect one end of the included Ethernet
network cable to the WAN port, and the
other end to the Ethernet port of the cable/
ADSL modem or Ethernet connection.
D
Connect one end of another Ethernet
network cable to the LAN port of the device,
and the other end to the Ethernet adapter on
your PC.
E
Connect two analogue telephone sets to the
Phone ports 1 & 2.
F
Connect the AC Power Adapter to the Power
and the other end into an electrical outlet.
G
Power on the following devices in this order:
PC, IMD-300 and cable or ADSL modem,
router.
C
D
E
F
Important:
Make sure to use the power adapter that is supplied with ITA-200. The use of different
power adapter could damage the ITA-200.
