PROGRAM INSTRUCTIONS (CONT)
9. Depress MODE (S1) switch once.
The text
SEt SP
will be displayed momentarily, followed by the current
value of Setpoint 1. Use S2, S3 and/or S4 to set a new value. To store
the selected parameter in non-volatile memory, depress the MODE
switch. To exit the MODE sequence, without storing the new parameter in
non-volatile memory depress the RESET switch. Reference Set SP in the
Function Definitions section for more information.
10. Depress MODE (S1) switch once.
The text
SP2 -
will be displayed. Reference SP1 - setup instructions
on Page 11 to set SP2 -.
11. Depress MODE (S1) switch once.
The text
SP2 HI or SP2 LO
will be displayed. Reference SP1 HI setup
instructions on Page 11 to set SP2 HI or SP2 LO.
12. Depress MODE (S1) switch once.
The text
SEt SP
will be displayed momentarily, followed by the current
value of Setpoint 2. Reference SEt SP setup instructions above to set
a new value for Setpoint 2.
13. Depress MODE (S1) switch once.
The text
SP3 -
will be displayed. Reference SP1 - setup instructions
on Page 11 to set SP3 -.
14. Depress MODE (S1) switch once.
The text
SP3 HI or SP3 LO
will be displayed. Reference SP1 HI setup
instructions on Page 11 to set SP3 HI or SP3 LO.
15. Depress MODE (S1) switch once.
The text
SEt SP
will be displayed momentarily, followed by the current
value of Setpoint 3. Reference SEt SP setup instructions above to set
a new value for Setpoint 3.
16. Depress MODE (S1) switch once.
The text
SP4 -
will be displayed. Reference SP1 - setup instructions
on Page 11 to set SP4 -.
Page 12
