Interflex Datensysteme GmbH
7/23
10.1 Fastening the PoE Terminal Board to the Back Panel of the Housing
Screw the terminal board to the threaded bolts on the metal back panel using the 2 screws included in
delivery.
Insert the network cable into the cutout on the metal back panel and plug it into the female connector on
the terminal board.
The key on the connector faces toward the wall. When disconnecting the RJ45
connector, use a small screwdriver to push the key on the connector upwards.
If an external power supply is being used, connect the wires to terminals AC- and AC+ and the protective
ground to terminal PE. Functional grounding is connected via the RJ45 connector and the hub/switch.
10.2 Plug-in Connection
The device and the PoE terminal board are connected by a 14-pin connector. The power supply as well as
the connection to the data lines takes place via this connector.
1
RJ45 female connector
2
Connector - female end. The female end of the connector faces upward, so that it can easily be connected to
the main board of IF-57xx.
3
PoE terminal board
4
14-pin connector on PoE terminal board
The 14-pin connector must be plugged into the PoE terminal board in such a way that
the female connector faces upward. When connecting the IF-57xx, make sure that the female end of the
connector can easily be connected to the main board. If necessary, adjust the connector.
11 Setting the Network Address
The address of the IF-57xx is preset (factory default) to 172.18.70.52.
Change the factory-set IP address after initial operation (for further information,
please refer to:
Configuring the Network Connection
).
Avoid double addressing.
Always put one device after the other into operation.
