9
For operation, appropriate credentials are required (transponder card, key or key tag).
The cylinder is delivered fully preassembled.
On delivery, the knob module is in the factory state and must be programmed before
initial operation/installation. In this regard, see the
Service Device
instructions for use.
All of the described proceedings always relate to a programmed knob module.
In the version for Mifare transponders, the knob must be "woken up" by turning it on
before every step.
Short-Time Release
"Wake up" the knob module by turning it.
Hold the authorized credential in front of the knob module.
or
A visual-acoustic signal sequence indicates that the knob module is in release mode (
/
green)).
After approx. 5 seconds, the knob module switches back to idle mode, i.e. it can be turned
"empty" again.
See also
Visual/Audible Signals ................................................................................... 17
Daily Release (Toggle Function)
Please note:
For this function, a credential with "Toggle Authorization" is required.
"Wake up" the knob module by turning it.
Hold the credential in front of the knob module until two visual-acoustic signal sequences
indicate that the locking cylinder is permanently released.
C
H A P T E R
3
Operation
Summary of Contents for IF15x
