15
3 Setting Up and Expanding
InterRAID-8
To set up the InterRAID-8 disk array with a system base unit, you will perform the following
tasks:
u
Connect the InterRAID-8 cabinet to the system base unit.
u
Expand the system (if installing additional disk arrays).
u
Install the RAID disk drives.
u
Power on and configure the system.
Connecting InterRAID-8 to the System
When setting up the InterRAID-8 cabinet in a vertical position, install the plastic feet on the
cabinet according to the Feet Installation instruction sheet. If setting up the cabinet
horizontally, install the rubber pads on the cabinet in the recessed area of each corner.
NOTE
To connect the rack-mount InterRAID-8 cabinet, refer to the system’s hardware
documentation for the rack-mounted system.
InterRAID-8 is available in two configurations, single-channel and dual-channel. The
single-channel cabinet has eight devices on one SCSI channel, and the dual-channel cabinet
has four devices on each of two SCSI channels. To determine whether you have a single-
channel or a dual-channel cabinet, look at the back of the cabinet. The single-channel
InterRAID-8 cabinet has only one SCSI port; the dual-channel cabinet has two SCSI ports.
Single-Channel
To connect the single-channel InterRAID-8 cabinet:
1. Connect one end of the RAID SCSI cable to the SCSI port on the InterRAID-8 cabinet.
Summary of Contents for InterRAID-12
