27
4 Setting Up and Expanding
InterRAID-12
To set up the InterRAID-12 disk array with a system base unit, you will perform the
following tasks:
u
Connect the InterRAID-12 cabinet to the system base unit.
u
Expand the system (if installing additional disk arrays).
u
Install the RAID disk drives.
u
Power on and configure the system.
Connecting InterRAID-12 to the System
When setting up the InterRAID-12 cabinet in a vertical position, first install the plastic feet
on the cabinet according to the Feet Installation instruction sheet. If setting up the cabinet
horizontally, install the rubber pads on the cabinet in the recessed area of each corner.
To connect the InterRAID-12 cabinet:
1. Connect a RAID SCSI cable to the channel 0 port on the RAID controller in the base
unit, and to the channel 0 port on the InterRAID-12 cabinet.
Channel 1
RAID
Controller
Board in Base
Unit
Channel 0
Summary of Contents for InterRAID-12
