69
SCSI Xfr Parameters
Data transfer rate
10 MHz
Command tagging
Enabled
SCSI data bus width
16 Bit
NOTE
The default SCSI Xfr parameters are: Data transfer rate = 10 MHz, Command tagging =
Enabled, SCSI data bus width = 16 Bit.
The Data transfer rate option sets the default SCSI negotiation rate for the selected SCSI
channel. The options are 10 MHz, 8 MHz, 5 MHz, and Asynchronous. The default is 10
MHz for the disk drives.
The Command tagging option enables or disables command tagging support for the selected
SCSI channel. The default is set to Enabled.
The SCSI data bus width option allows you to select either 8 Bit or 16 Bit parameters.
Verify that 16 Bit is enabled.
Startup Parameters
The options for the Startup Parameters (Spin up option, Number of devices per spin, and
Delay) can be used to set up the way the disk drives spin initially. However, by default, the
InterRAID cabinet power supplies manage how the drives spin up, so these options do not
need changing. The disk drives spin up one at a time, with a four-second delay between spin
up. If you change the Spin up parameter to Automatic, then the Devices per spin and Delay
parameters can also be changed. The following menu shows the startup parameters.
NOTE
This parameter only applies to the disk drives in the disk array, not to other SCSI devices.
Startup Parameters
Spin up option
On power
Number of devices per spin
0
Delay (seconds)
0
NOTE
The default startup parameters are: Spin up option = On power, Number of devices per spin
= 0, Delay (seconds) = 0.
Summary of Contents for InterRAID-12
