pH
Free chlorine(mg/1)
TAC(mg/1)
Salt(g/1)
Important: failure to comply with these limits will invalidate the warranty.
Note: exceeding one or
several limits can
damage
the
heat
pump
beyond
repair.
Always
install
water
treatment equipment past the heat pump's
water
outlet,
especially
if
the
chemicals
are
automatically
added to the water.
A
check-valve should also be
installed
between the outlet of the heat pump and this equipment
in
order
to prevent products from flowing back into the heat pump if the filter
pump stops.
4. Guidelines
4.1
Water
chemistry
Special attention should be paid to the chemical balance of the pool water. The pool water values
should always stay within the following limits:
4.2
Winterizing
Important: failure to winterizing could damage the heat pump and will void warranty
The heat pump, filter pump, filter and conduits must be protected in areas where the temperature can
drop below the freezing point, Evacuate all water from the heat pump as follows:
1. Turn off the electrical power supply to the heat pump
2. Close the water supply to the heat pump: completely close valves 2 and 3 of the by-pass
3. Disconnect the water inlet and outlet coupler fittings of the heat pump and let the water drain out of
the unit
Min
7.0
0.5
80
Max
7.4
1.2
120
3
4.3 Spring startup
If your heat pump has been winterized, perform the following steps when starting the system in the
spring:
1. Inspect the system for any debris or structural poroblems.
2. Connect the water inlet and outlet unions firmly.
3. Turn on the filter pump to supply water to the heat pump. Adjust the by-pass to allow water flow
through the heat pump.
4. Turn on the electrical power to the heat pump at the main breaker panel.
3
8
EN
Summary of Contents for 59695325
Page 17: ...7 Elektrisch schema van de warmtepomp 15 NL ...
Page 37: ...3 15 7 Wiring diagram EN ...
Page 57: ...7 Schaltplan 15 DE ...
Page 77: ...7 SCHÉMA DE CÂBLAGE 15 FR ...
