Chapter 4: Commands for CLI configuration
evc update
Command:
evc update <EvcId : 1-4096> vid <evc_vid> ivid <ivid>
interface ( * | 10GigabitEthernet | GigabitEthernet
[ <port_list> ] ) learning [ disable ] policer { <PolicerId : 1-
2048> | none | discard }
<EvcId : 1-4096>
EVC identifier
vid
Setup EVC VLAN ID
<EvcVid : 1-4095>
EVC VLAN ID
ivid
Setup internal EVC VLAN ID
<Ivid : vlan_id>
Internal VLAN ID
interface
Setup NNI
learning
Setup learning
policer
Policer (ingress bandwidth profile)
<PolicerId : 1-2048>
Policer ID
<vlan_list>
List of VLANs
discard
Map to policer discarding all frames
none
Map to policer allowing all frames
Default:
0
Usage Guide:
To update an ID for
Ethernet Virtual Circuits (EVC)
.
Example:
To update
Ethernet Virtual Circuits (EVC identifier: 1, EVC VLAN ID: 10)
.
Switch# configure terminal
Switch (config)#
evc update 1 vid 10
exit
Command:
exit
Default:
N/A
Usage Guide:
To exit
configure terminal
mode.
Example:
To exit
configure terminal
mode.
Switch# configure terminal
Switch (config)#
exit
#
58
NS3500-24T-4C Managed Switch Command Guide
