Chapter 4: Commands for CLI configuration
access-list rate-limiter
Command:
access-list rate-limiter <RateLimiterId : 1-16>
rate-limiter
Rate limiter
<RateLimiterId : 1-16>
Rate limiter ID
Default:
Disable
Usage Guide:
To apply
Rate Limiter ID
for the
ACL
.
Example:
To apply
ACL
Rate Limiter ID 1
for the
GigabitEthernet X/X
.
Switch# configure terminal
Switch (config)#
interface GigabitEthernet X/X
Switch (config-if) #
access-list rate-limiter 1
access-list redirect interface
Command:
access-list redirect interface 10GigabitEthernet
<port_type_list> | GigabitEthernet <port_type_list>
redirect
Redirect frame to specific port
Default:
Disable
Usage Guide:
To redirect frames to specific Port
.
Example:
To redirect
GigabitEthernet X/X
frames to
GigabitEthernet 1/2
.
Switch# configure terminal
Switch (config)#
interface GigabitEthernet X/X
Switch (config-if) #
access-list redirect interface
GigabitEthernet 1/2
access-list shutdown
Command:
access-list shutdown
shutdown
Shut down incoming port. The shutdown feature only works when the
packet length is less than 1518 (without VLAN tags).
Default:
Disable
Usage Guide:
To enable
Shutdown
function
for the
ACL
.
Example:
To enable
ACL
Shutdown
function
for the
GigabitEthernet X/X
.
NS3500-24T-4C Managed Switch Command Guide
65
