P/N 75007040.Y71
• REV B • ISS 21MAR19
3 / 4
Switching points
Details can be found at Figure 6.
It is possible to adjust the switch point of the bolt contact with a
locking disk on to the designated switch point.
Set the switch point 1 until 4 with the tip of a screwdriver. Raise
the locking disk on the notch and turn until it engages again.
Schematic
Technical data
Item No.
RK100-N
Contact termination
3 soldered terminals
Protection category
IP50/DIN 40050; VdS environmental class II
VdS Class
C
VdS No
G 110103
Designated use
For mounting on interior doors
Contact capacity
max. 3 W / VA
Switch voltage
max. 30 VDC
Switch current
min. 5 mA
Switch current
max. 300 mA
Contact type
Change over
Temperature at fixed
cable
−25°C to +70°C
Temperature at
moveable cable
−5°C to +50°C
Switch point
Adjustable
Cycles of operation
min. 30,000
Regulatory information
Manufacturer
PLACED ON THE MARKET BY:
UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092,
USA
AUTHORIZED EU REPRESENTATIVE:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Certification
Product warnings
and disclaimers
THESE PRODUCTS ARE INTENDED FOR
SALE TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. UTC FIRE & SECURITY
CANNOT PROVIDE ANY ASSURANCE THAT
ANY PERSON OR ENTITY BUYING ITS
PRODUCTS, INCLUDING ANY “AUTHORIZED
DEALER” OR “AUTHORIZED RESELLER”, IS
PROPERLY TRAINED OR EXPERIENCED TO
CORRECTLY INSTALL FIRE AND SECURITY
RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
European Union
directives
UTC Fire & Security hereby declares that this
device is in compliance with the applicable
requirements and provisions of the Directive
2014/30/EU and/or 2014/35/EU. For more
information see www.utcfireandsecurity.com or
www.interlogix.com.
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.recyclethis.info
Contact information
For more information visit our website:
www.utcfireandsecurity.com.
DE: Montageanleitung
Montageort
Der Riegelschaltkontakt ist zur Montage u.a. im
Türschließblech zur Verschlussüberwachung der Verriegelung
geeignet. Die Betätigung des Riegelschaltkontaktes erfolgt
durch den Schloßriegel. Die Meldung kann für
Einbruchmeldeanlagen und Überwachungssysteme
ausgewertet bzw. angezeigt werden.
Lieferumfang (siehe Abbildung 2)
1. Riegelschaltkontakt
2.
Hebelverlängerung (Kunststoff)
3.
Hebelverlängerung (Metall)
4. Kunststoffhalter
5. Blechschraube 2,2 x 4,5
6. Senkkopfschraube M3 x 6
7. Montageanleitung
Abmessungen
Siehe Abbildung 3.
