2. Select
System
and then select
Maintenance
on the left menu.
3. Select
Reboot
.
4. Select
OK
when asked to reboot the unit.
Note:
Reboot may take up to two minutes.
5. Go to the
Live View
tab in the TruVision configuration browser
to verify live video.
Camera installation is now complete!
Alternative methods of adding cameras
Add cameras via Ethernet with a Windows PC
1. Apply power to the camera.
Note:
It may take up to two minutes for the camera to boot up.
2. Connect the camera to a router with an Ethernet cable.
3. Launch TruVision Device Manager.
Note:
Install TruVision Device Manager using the included CD
or download it from www.interlogix.com/video.
4. Verify that the camera is found in the main camera selection
window.
5. Select the camera to be configured.
6. In the
Password
field, type the default password (1234) and
click
Save
.
7. In the main camera selection window, select the camera to be
configured and double-click the IPV4 Address to launch
TruVision IP Camera Configurator in a browser.
Note:
The Camera Configurator can also be launched by
typing the camera’s IP address into an internet browser. The
default camera IP address is 192.168.1.70 in a network
without a DHCP server.
8. The TruVision Configurator appears. Enter the credentials
below:
User Name
: admin
Password
: 1234
9. Tap
Network
and then tap
Basic Settings
on the left menu.
10. Change LAN settings to the required configuration. If a static
IP Address is required, change the
IPv4 Address
and
IPv4
Subnet Mask
to match the router.
a. Change the static IP address to something different than
the default 192.168.1.70 if more than one camera is used
on the network.
P/N 1073278-EN • REV A • ISS 09MAY17 © 2017 United Technologies Corporation. All rights reserved.
17
