28
Installation Guide
Setting up the camera
Note:
If the light source where the camera is installed
experiences rapid, wide variations in lighting, the camera may
not operate as intended.
To quickly put the camera into operation:
1. Prepare the mounting surface.
2. Mount the camera on the mounting surface using the
appropriate hardware.
3. Set up the camera’s network and streaming parameters
so that the camera can be controlled over the network.
For further information, please refer to the “TruVision IP
Series 3 IP Camera Configuration Manual”.
4. Program the camera to suit its location. For further
information, please refer to the “TruVision IP Series 3 IP
Camera Configuration Manual”.
Accessing the SD card
Insert a Micro SD card with up to 128GB capacity for local
storage as a backup in case, for example, the network fails
(see Figure 2 on page 21). The SD card is not supplied with
the camera.
For the IP VF lens dome and IP motorized dome cameras,
point the lens vertically upwards to access the SD card slot.
For the IP VF bullet and IP motorized bullet cameras, remove
the sunshield and open the front cover to access the SD card
slot.
Video and log files stored on the Micro SD card can only be
accessed via the web browser.
Summary of Contents for TVB-5301
Page 1: ...TruVision Series 3 IP Camera Installation Guide P N 1073188 EN REV E ISS 22SEP17 ...
Page 4: ......
Page 67: ......
Page 68: ......
