Chapter 5: Advanced setup
56
TruVision DVR 10 User Manual
2. Select the cameras you want to record for motion detection.
Select the cameras you want to begin recording when the system receives a
motion detection alarm. Check one of the camera boxes to select that
camera. Click again to deselect. You can select more than one camera.
Note:
For cameras to be able to record for a motion detection alarm, you
must first configure them for motion recording. See “Defining a recording
schedule” on page 63 for more information.
3. Define an alarm schedule.
The system’s handling of a motion detection alarm depends on the alarm
schedule. On the Motion Detection Alarm Rules screen, select the day of the
week in the Alarm Schedule list box for which you want to set the response
time schedule. Enter the time period for the response in the Period 1 edit
boxes. You can enter up to four time periods for each day of the week. The
four daily time periods cannot overlap.
Use the Copy option to copy the same periods to a different weekday.
Note:
You will be prompted to reboot the TVR 10 in order for the schedule to
take effect.
4. Select a response method.
Check a response method for the system when a motion detection alarm is
triggered. You can check one or more response methods including:
Full Screen.
Displays the alarm on the screen.
Buzzer.
An audible alarm sounds.
Upload to Client.
This feature is currently not supported.
Alarm Out.
Triggers an alarm output. Up to four alarm outputs can be
enabled.
Summary of Contents for TVR-1004-1T
