ZERO-CROSSING ACTION FOR RELAY
The Power Pack makes every motion of the relay in the vicinity of AC zero crossing and the deviation of +/- 20% in order to increase the reliability of movement and
life of the relay. The DC does not have zero-crossing protection.
DESCRIPTION OF THE POWER PACK LED INDICATORS
The Power Pack LED, located on the side of the Power Pack, indicates the following conditions:
LED state
Indicates
In the OFF state (not illuminated)
There is no power to the sensor or the +24 VDC output is shorted
LED is flashing every two seconds and is off for
Relay is closed (load ON)
0.5 seconds
LED normally ON
The relay is open (load OFF)
TROUBLESHOOTING
The lights do not turn on automatically after they are
The occupancy sensor time delay is too long. Reduce the time delay.
turned off for a presentation
Increase occupancy sensor sensitivity
The load does not turn ON when occupancy is detected by the
The Hold OFF input is active. De-activate the Hold ON input.
sensor.
The load does not turn OFF after the sensor time delay expires. The Hold ON input is active. De-activate the Hold ON input.
The load does not respond when the momentary switch is
Check the wiring and the switch.
pressed.
158--02131REF
LIMITED WARRANTY
Warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased or (b) completing a warranty claim online at www.intermatic.com. This warranty is made by: Intermatic
Incorporated, 1950 Innovation Way, Suite 300, Libertyville, IL 60048. For additional product or warranty information go to: http://www.Intermatic.com or call 815-675-7000.
