Battery Recycling Information
This product contains or uses a lithium ion (Li-ion) main battery. When
the battery reaches the end of its useful life, the spent battery should be
disposed of by a qualified recycler or hazardous materials handler. Do
not mix this battery with the solid waste stream. Contact your Intermec
Technologies Service Center for recycling or disposal information.
802.11 Radio Precaution Statement
Caution:
Users are responsible for configuring the channels of operation that
comply with their country regulatory standards. A Wireless Network
Administrator should review the operating restrictions detailed within the
Access Point installation manual.
Radiation Exposure Statement
Warning:
This equipment complies with International Commission on Non-
Ionizing Radiation Protection (ICNIRP), IEEE C95.1, Federal Communications
Commission Office of Engineering and Technology (OET) Bulletin 65, Canada
RSS-102, and European Committee for Electrotechnical Standardization
(CENELEC) limits for exposure to radio frequency (RF) radiation.
If a body worn accessory is not purchased from Intermec, the accessory must contain
no metal and provide a 1.2 cm (0.5 in.) space between the device and the body.
Tech Com will assign the appropriate path ):
To find RF exposure information, go to
www.intermec.com
> Products > Computers
(e.g.)
> Handheld Computers
(e.g.)
> CN70
(e.g.)
> Manuals
tab and scroll down to
Regulatory Information.
Laser Compliance and Precaution
The 1000CP01F9 and 1000CP02F9
are registered with the CDRH as a Class 2
LASER Product (21 CFR Subchapter J, Part 1040). This product has a maximum
output of 1 mW at 630-670 nm.
Caution:
There are no user serviceable parts inside the 1000CP01F9 and
1000CP02F9
.
Use of controls or adjustments, or performance of procedures
other than those specified herein, may result in hazardous laser light exposure
of up to 1 mW at 630-670 nm.
Note:
There are no controls or adjustments provided for routine operation or
maintenance of the 1000CP01F9 and 1000CP02F9
.
