SECTION 3
Supporting Windows Applications
PEN*KEY
R
6200/6300 Hand-Held Computer Programmer’s Reference Guide 3-21
Hardware Interface
These entries initialize the hardware interface. Most of them default to
PEN*KEY values and do not need to be set.
PortAddr
Decimal digitizer base I/O port address. Should not need to be specified for the
PEN*KEY HHC.
Valid values:
0 to 1023
Default:
520
IrqLevel
Decimal IRQ level used by digitizer. Should not need to be specified for the
PEN*KEY HHC.
Valid values:
0 to 15
Default:
12
BaseClock
Base clock value for Gazelle/Logitech digitizer.
Valid values:
0 = 33 MHz
1 = 2 MHz
2 = 14 MHz
Default:
0
"
NOTE:
The only value that is supported by the PEN*KEY HHC is 0. This value should not need
specification for the PEN*KEY HHC.
PointsPerSecond
Initial digitizing rate in packets per second. The default value is sufficient when
using the pen only as a pointing device. Values between 100 and 150 give better
results when using handwriting recognition, such as when Windows for Pen
Computing is installed.
Valid values:
1 to (approximately) 200
Default:
50
MaxIPS
The fastest movement allowed in inches/second. This value should not need
specification for the PEN*KEY HHC.
Valid values:
0 to (approximately) 150
Default:
75
3. Windows
Applications
